Form 2000-100, Facility Identification Form 2000-101, Facility Plot Plan Forms 2000-102, -102A, and -102B, Source and Site Descriptions Form 2000-200, Stack Identification Form 2000-300, Boiler or Furnace Operation Form 2000-301, Storage Tanks Form 2000-302, Internal Combustion Engine Form 2000-303, Incineration Form 2000-304, Printing Operations
Complete one form for each boiler or furnace with significant emissions. Item 1 Provide the name of the facility. Item 2 Provide the facility identification (FID) number that appears on the annual emission inventory reports. Item 3 Provide the identification number for the stack exhausting this boiler or furnace. Use the same number used on form
Compliance for Industrial, Commercial, and Institutional Area Source Boiler…
See related content like products and images with every search.
This number will appear on Form 4500-iD: Fuel Burning Equipment, Form 4500-iS: Stack Identification, and Form 4500-iC: Air Pollution Control Equipment completed for this boiler. The collector could be assigned the identification number C-i, which should then appear on the same forms 1B, 1C, and iS.
the form. The Unique Source ID should be a simple name/number/letter designated by the applicant which uniquely identifies the equipment covered by the application. Examples of a Unique Source ID are Boiler #1, Boiler A, Engine #1, Engine A, Paint Line #1, or Paint Line A. It will be used to identify the equipment under
Gas-fired Boiler and Heater Division of Air Pollution Control Submission of this form constitutes notice that the party identified in Section I of this form intends to be authorized to install/operate a source of air pollution according to the permit-by-rule provisions of OAC Kefid(A)(4)(a), and (j). By submitting this form, the applicant agrees to operate and
Boilers should be designed and constructed in accordance with the requirements of ASME CSD-1, 1 and gas-fired boilers should conform to the requirements listed in Chapter 24 of the IRC. Gas-fired boilers should be listed and labeled in accordance with IRC M1302.1, and should be installed: In accordance with the manufacturer's instructions G2408.